Publicité
MS-7678 Manboard
▶
DRAM Rato
Ths settng controls the rato of memory frequency to enable the memory to run at df-
ferent frequency combnatons.
▶
Adjusted DRAM Frequency
It shows the adjusted DRAM frequency. Read-only.
▶
Extreme Memory Profile(X.M.P)
Ths tem s used to enable/dsable the Intel Extreme Memory Profile (XMP). For further
nformaton please refer to Intel's offical webste.
▶
DRAM Tmng Mode
Select whether DRAM tmng s controlled by the SPD (Seral Presence Detect) EE-
PROM on the DRAM module. Settng to [Auto] enables DRAM tmngs and the followng
"Advanced DRAM Configuraton" sub-menu to be determned by BIOS based on the
configuratons on the SPD. Selectng [Lnk] or [Unlnk] allows users to configure the
DRAM tmngs and the followng related "Advanced DRAM Configuraton" sub-menu
manually.
▶
Advanced DRAM Configuraton
Press <Enter> to enter the sub-menu.
▶
Command Rate
Ths settng controls the DRAM command rate.
▶
tCL
Ths controls the CAS latency, whch determnes the tmng delay (n clock cycles)
before SDRAM starts a read command after recevng t.
▶
tRCD
When DRAM s refreshed, both rows and columns are addressed separately. Ths
setup tem allows you to determne the tmng of the transton from RAS (row ad-
dress strobe) to CAS (column address strobe). The less the clock cycles, the faster
the DRAM performance.
▶
tRP
Ths settng controls the number of cycles for Row Address Strobe (RAS) to be
allowed to precharge. If nsufficent tme s allowed for the RAS to accumulate ts
charge before DRAM refresh, refreshng may be ncomplete and DRAM may fal
to retan data. Ths tem apples only when synchronous DRAM s nstalled n the
system.
▶
tRAS
Ths settng determnes the tme RAS takes to read from and wrte to memory cell.
▶
tRFC
Ths settng determnes the tme RFC takes to read from and wrte to a memory
cell.
▶
tWR
Mnmum tme nterval between end of wrte data burst and the start of a precharge
command. Allows sense amplfiers to restore data to cells.
En-28
Publicité
