Publicité
CONTROL PANEL - BE12500T
3
1 12
2
8
9
8
17
SYSTEM BONDED TO FRAME
SYSTÈME LIÉ AU CADRE
15
14
13
6
11
7
4
7
5
16
10
1: Light Switch - Press once to turn the LED light on. Press again to turn the light off.
2: LED Light
3: Engine Switch - Press ON to start the engine, press OFF to turn the engine off.
4: Low Oil Indicator - If this light glows red, it means the engine is low on oil.
5: Carbon Monoxide Alarm - A flashing red light indicates a dangerous build up of
carbon monoxide gas has been detected in the area the generator is located. Vacate
this area immediately until it has been aired out. A flashing yellow light indicates a
malfunction in the carbon monoxide sensor and it needs to be serviced.
6: Main Breaker - A circuit breaker interrupts the current when the circuit has been
overloaded.
7: 120V AC 20A 5-20R Outlet - The outlet is capable of carrying a maximum of 20 amps.
8: AC Protector - If the generator is overloaded, the AC protector will trip and block
current.
9: 120/240V AC 30A L14-30R Outlet - The outlet is capable of carrying a maximum of 30
amps.
10: Ground Terminal - The ground terminal is used to externally ground the generator.
11: Voltage Switch - Allows the user to switch between 120 and 240 volts as needed.
12: DC Protector - If the generator is overloaded the DC protector will trip to block current
13: 12V DC Outlet - 12 volt DC 8 amp outlet.
14: ECO Mode - When turned on, the engine will conserve fuel by sensing the necessary
load and running at a lower RPM to save fuel.
15: One Touch Start - Pressing this button will start the generator without having to pull
the recoil.
16: Battery charging Port - Allows the user to charge their battery.
17: 120/240V AC 50A 14-50R Outlet - The outlet is capable of carrying a maximum of 50
amps.
11
Publicité
