Publicité
04P-0037/HSF04WNBBB
English
9. Align the pin of the top hinge with top hole on the left
side of the door and push into place. Replace the screws in the
upper hinge bracket but do not tighten all the way. (see fig. # 2)
10. Make sure the door closes easily but forms a tight seal.
Adjust the door as needed. Once you are satisfied with the door
alignment, completely tighten the upper door hinge screws.
11. Replace the hinge cover, insert the screw and tighten completely. (see
fig. # 2)
12. If the door does not close properly, refer to the section titled
"Door Alignment".
NOTE: As the door gets pressed-in during shipping, after reversing the
9
7/23/04
5:44 PM
Page 11
screw hole plug
door the gasket may have to be reset. This is done to prevent the
cool refrigerated air from escaping. If there is a gap between the
door gasket and the cbainet, set the gasket by gently pulling it out
to seal the gap.
door pin
fig. # 3
lower hinge bracket
Publicité
