CDVI V1SR Mode D'emploi page 4

4] WIRING AND CONNECTIONS
12Vdc default setup
Terminal
Correspondence
block
+
12 or 24Vdc
- 0V
N.C. NC (Normally closed)
COM COM
N.O. NO (Normally open)
The NO/NC signal only switches when
the door is closed with the power to it
activated.
Voltage Selection Jumpers
V3SR / V5SR
Default set up
12V dc
V3SR1248 / V5SR1248
Default set up
Fire remote
4
V1SR, V3SR, V3SRB, V4SR, V5SR, V5SRB
Internal surface electro-magnetic locks range
Default set up
24V dc
Push button
Check the jumper position before
connecting the lock to he input
current! A wrong position could
damage the lock.
This type of damage is not covered
by the warranty.
V4SR
12V dc 24V dc
- + + NC C NO
-
V3SRB / V5SRB
Default set up
12V dc 24V dc
Do not change the
position of the jumper
unless you are using the
maglock in fire setting
with a remote.
EN