Publicité
WARNING
The high pressure stream of water that this
equipment produces can pierce skin and its
underlying tissues, leading to serious injury
and possible amputation.
Spray gun traps high water pressure, even
when engine is stopped and water is
disconnected, which can cause injury.
• Keep high pressure hose connected to pump and spray
gun while system is pressurized.
• ALWAYS point gun in safe direction and squeeze spray
gun trigger, to release high pressure, every time you stop
engine. Engage trigger lock when not in use.
IMPORTANT: Spray gun traps high water pressure,
even when engine is stopped and water is
disconnected.
4. Engage trigger lock on spray gun when not in use.
How To Use the Adjustable Nozzle
You now should know how to START your pressure
washer and how to STOP it. The information in this
section will tell you how to adjust the spray pattern
and apply detergent or other cleaning chemicals.
On the end of your spray gun is a nozzle handle that
can adjust the spray pressure and the spray pattern.
CAUTION
A pressure washer produces a high pressure spray
which increases risk of injury and damage to unit.
• NEVER adjust spray pattern when spraying.
• NEVER put hands in front of nozzle to adjust spray pattern.
1. Sliding nozzle forward and back adjusts spray
pressure.
Slide nozzle backward for
high pressure mode.
Slide nozzle forward for low
pressure mode and
detergent application.
2. Point nozzle toward ground, disengage trigger
lock, and press trigger to test pattern.
3. Rotating nozzle adjusts spray pattern from a
narrow pattern to a fan pattern.
Twist nozzle counter-
clockwise for fan pattern.
4. For most effective cleaning, keep spray nozzle
between 8 to 24 inches away from cleaning
surface.
5. If you get spray nozzle too close, especially using
high pressure mode, you may damage the surface
being cleaned.
6. DO NOT get closer than 6 inches when cleaning
tires.
Using the Turbo Nozzle
The turbo nozzle rotates the high pressure stream in a
rapid circular pattern. The high pressure spray is most
effective when the tip of the nozzle extension is held
between 8 to 24 inches from the surface being cleaned.
The turbo nozzle produces an extremely high
pressure spray which is capable of removing paint
and cutting holes through surfaces if held too close.
• Always make sure the surface you will clean will not be
damaged by the high pressure spray by testing in a
hidden area.
To attach the turbo nozzle to the spray gun:
1. Engage trigger lock on spray gun trigger.
2. Remove the nozzle extension from the spray gun,
if attached.
11
Twist nozzle clockwise for
narrow spray pattern.
CAUTION
Publicité
