Publicité
PACKING LIST
Pressure Washer
35 ft. High Pressure Hose
Handle
Trigger Handle
Spray Wand
Quick-Connect Nozzles (2
Storage Panel
Screws (4)
Nuts (4)
4-Cycle Engine Lubricant (SAE 30 or SAE 10W30)
Disposable Funnel
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
TOOLS NEEDED
See Figure 2.
The following tools (not included or drawn to scale) are
needed for assembly:
„ Phillips Screwdriver
„ 10 mm Wrench
INSTALLING THE HANDLE
See Figure 3.
CAUTION:
Be careful to avoid pinching your fingers or hands when
installing the handle onto the frame.
ASSEMBLY
Story, 25°, 40°, Soap)
nd
Push and hold the button on the handle as you slide the
handle into the holes in the frame.
NOTE: Before use, pull the handle up until the lock button
snaps through the locking slot to secure the handle in place.
INSTALLING THE STORAGE PANEL AND
TRIGGER HANDLE HOLDER
See Figure 4.
„ Align the holes in the storage panel and trigger holder
with the holes in the handle, as shown.
„ Insert screws through the holes (when viewed from front).
Install nuts and tighten securely using a Phillips screw-
driver and 10 mm wrench (not provided).
CONNECTING THE SPRAY WAND TO THE
TRIGGER HANDLE
See Figure 5.
„ Place the threaded end of the spray wand in the connec-
tor on the end of the trigger handle.
„ Fully tighten the connector to secure the spray wand in
place.
CONNECTING THE HIGH PRESSURE HOSE
TO THE TRIGGER HANDLE
See Figure 6.
„ Screw the collar on the high pressure hose into the trigger
handle inlet coupler by turning the hose collar clockwise.
Tighten securely.
NOTE: Be careful to avoid cross-threading, which can
cause the trigger handle to leak during use.
„ Pull on the hose to be certain it is properly secured.
CONNECTING THE HIGH PRESSURE HOSE
TO THE PUMP
See Figure 7.
„ Completely uncoil and straighten the high pressure hose
to prevent kinks.
NOTE: See Using the High Pressure Hose in Operation
for more information about using the high pressure hose.
„ Align the collar on the hose to the threaded outlet on
the pump.
„ Install the high pressure hose collar onto the threaded
outlet.
„ Turn the collar clockwise to tighten the hose securely to
the pump.
NOTE: Be careful to avoid cross-threading, which can
cause the hose to leak during use.
„ Pull on the hose to be certain it is properly secured.
7 — English
Publicité
