Publicité
EN
A. FITTING INSTRUCTIONS AND DIRECTIONS FOR USE
This device has been designed exclusively for fixing plasterboard panels. Any other use of this
equipment is strictly forbidden and no responsibility can then be assumed by the manufacturer.
Make sure that this device is not used in open premises which might be exposed to violent winds.
The wheels of the EASY PRO LEVPANO® must be on level ground without any major obstacle.
Any modification to the arms, including for an use other than that provided for by the manufacturer,
is forbidden.
This device is a hand-operated lifting device used to fix plasterboard panels.
Read the indicator plate on the device carefully.
1. Fitting the various elements of the Levpano
Proceed with the following operations :
Position the base on the 4 wheels, putting in place the 2 hooks.
Lock 2 wheels provided with a brake in order to facilitate the putting in place of the parts.
Fit the 2 wooden platforms inserting respectively their 2 holes onto the screws intended for their
fastening. Unscrew then slightly, then move the platforms a little and fix them firmly using the 4
screws.
Position the head in the top part of the inner column, adjust the head extension tube according to
the fixing height required, then lock the head with relation to the column, introducing the clips pin
into the corresponding hole of the extension tube.
Maximum fitting height, horizontal panel 3.5 m
Loading height for horizontal fitting
Fit the beam in the tilting head housing intended for this purpose.
Assemble the 2 single tubes with each of the tubes equipped with removable stops, using the M8 x
50 hexagon bolts.
After having assembled the 2 end arms, put them on the centre beam, making sure that the
removable stops are situated opposite the winch and immobilise the arms on the beam, by means
of the 2 "clips" pins in the position corresponding to the plate, according to its length.
For the most common adjustment corresponding to a plate of 2.5 m, this value is shown on the
tube of the arms.
2. Fitting the winch's handle
For reasons of convenience and safety during transport, the winch's handle (item ) is
NOTE :
supplied dismantled
Fit the handle (item 1) on its pin, bringing it as far as it will go against the washer (item 2) (without
applying force). Lock the winch's coil to perform this operation.
Fit the washer (item ) onto the screw (item ), then screw the latter on the handle's pin and lock it.
Lock also the winch's coil to perform this operation.
A1
.
3.6 m
3.7 m
0.81 m 0.91 m 1.01 m 1.11 m 1.21 m 1.31 m
3.8 m
3.9 m
4 m
Publicité
