Sentiotec CP-RM-35 Instructions D'installation Et D'utilisation page 24

Instructions for use for the user
1. Remove the old sauna stones.
2. Clear the stone container of limescale deposits, dust and other contamination.
3. Wash the stones thoroughly using water and a brush before use. Do not
use any cleaning additives.
4. Before filling the heater with the sauna stones, check them for foreign objects
and remove any remaining packaging.
5. Place the stones in the stone container. Stack the sauna stones loosely so
that air can flow through the gaps.
6. Make sure that the sauna stones do not protrude beyond the edge of the
stone container.
8. Disposal
● Please dispose of packaging materials in accordance with the
applicable disposal regulations.
● Used appliances contain reusable materials as well as hazardous
substances. Therefore, do not dispose of your used appliance with
household waste, but rather do so in accordance with the locally
applicable regulations.
9. Problem-solving by the installer
Baking out of the heating rods
Moisture can accumulate in the heating rods in humid ambient conditions or dur-
ing long periods of non-use. This is a physical process and not a manufacturing
fault. Under certain circumstances, accumulation of moisture in the heating rods
can lead to the FI circuit breaker being triggered.
In this case, it is necessary to bake out the sauna heater under the supervision
of an electrician. To do this, the protective function of the FI circuit breaker must
be switched off. The baking out procedure takes approximately 10 minutes.
The safety function of the FI circuit breaker must subsequently be reactivated.
If the problem persists, consult your supplier.
p. 24/26