Publicité
Switching on the appliance
When connected, the appliance is switched on. A
warning signal sounds.
Press the Alarm/lock button. The warning signal
switches off.
Display "alarm" goes out when the appliance has
reached the set temperature.
Note
Do not make any further settings on the appliance
within the first 30 seconds after switching on.
The preset temperatures are reached after several
hours. Do not put any food in the appliance
beforehand.
The factory has recommended the following
temperatures:
▯
Freezer compartment: -18 °C
▯
Refrigerator compartment: +4 °C
Setting the temperature unit
The temperature can be displayed in degrees Celsius
(°C) or degrees Fahrenheit (°F).
Setting the temperature unit
To set the temperature unit, simultaneously press the
"super" button and the "options" button for 5 seconds.
Depending on the previous setting, the display
switches to the other temperature unit.
Setting the temperature
The required area must be selected before
temperatures can be set for the different climatic
zones (refrigerator compartment, freezer
compartment):
1.
Keep pressing the "select" button until
the required climatic zone is marked with
an arrow.
2.
Set the temperature with the + (warmer) or -
(cooler) setting buttons.
The value last indicated is saved by the system.
Freezer compartment
The freezer compartment can be set from -16 °C to
-24 °C.
We recommend a setting of -18 °C.
38
Refrigerator compartment
The refrigerator compartment can be set from +2 °C
to +8 °C.
The temperature can be set at 1 °C intervals.
Perishable food should not be stored above +4 °C.
We recommend a setting of +4 °C.
Special functions
[timer]
You can use this function to set a period of time of 0-
99 minutes. A signal reminds you, e.g. when food is
to be taken out of the compartment after a certain
time.
A value of 20 minutes has been preset at the factory.
m
Caution
Drinks bottles may crack if they are stored for longer
than 20 minutes in the freezer compartment.
Switching on [timer]
1.
Keep the Options button pressed until the [timer]
function is marked with an arrow.
2.
Activate by pressing the setting button + or -
(function is framed).
3.
Press the setting buttons +/- to set the desired
time.
Publicité
