Publicité
Assembly Steps for Ride-On Feature
E
Insert the wheel J and the
8x16mm washer T in
sequence onto the iron rod
of steering part E, and
secure them with pin P.
L
V
Insert the steering
hardware part L as shown,
along with the 10x20mm
washer V.
Place the steering
assembly as shown, and
hook the bent end of the
steering hardware into the
central groove.
Then fit the steering wheel
onto the upper end of the
steering shaft and align it
with the side holes.
J
Align the clips of the wheel
trim ring K with the wheel
slots and press firmly.
A
Insert the straight end of
the steering hardware part
L through the round hole
at the bottom of the car
body A.
Align the two steel wall
nails R with the screw
holes of the steering part
and tighten to secure.
Insert the screw O through
the side hole of the
steering wheel B and
secure it with a nut.
K
Assemble the other wheel
in the same way,
completing the assembly
of the steering part.
Pass the steering
hardware part L through
the center hole of the front
section, leaving one end
exposed for later use.
Insert the steering wheel B
into the steering wheel
connector C.
Take the left and right
rearview mirrors F, align
them with the slots on the
front of the car, and press
down to lock them in
place.
4
B
C
F
Publicité
