Publicité
Fit an 8x16mm washer T
onto the rod M.
Continue by sequentially
fitting the wheel J and the
8x16mm washer T, then
insert the pin P into the
hole at the end of the rod.
D
Insert the backrest D into
the hole at the rear of the
car body and press until it
fully locks into place.
Assembly Steps for Push Function
Fit the armrest H onto the
rotating shafts on both
sides of the backrest as
shown.
Then, sequentially fit the
wheel J and two spacers
S.
Align the clips of the wheel
trim ring K with the wheel
slots and press firmly.
The assembly of the ride-
on feature is now
complete.
Rotate forward, and lock
the rear handle clip onto
the steering wheel.
5
Insert the rod M through
the aligned holes, passing
it through the rear base of
the car body A, and then fit
two more spacers S.
Place the anti-tip frame N
in the position shown in
the diagram and secure it
with steel wall nails Q.
Align the push bar G with
the stopper on the
backrest, press the push
bar button, and insert the
bar into the backrest.
Publicité
