•
If setting the temperature, press the
change the temperature in one degree increments. When pushing either button for the first time, the
readout will show the original temperature set.
Pressing the
•
Pressing the
•
NOTE: When using the unit for the first time or after a long period of inactivity, they may be a variance of a
few degrees between the selected temperature and the temperature indicated on the LED readout. This is
normal due to the length of inactivity and will correct itself after the unit has run for a few hours. If the unit is
unplugged, has lost power, or is turned off, wait 3 to 5 minutes before restarting the unit. The unit will not
restart before this time delay.
STORING WINE
Note: Bottle capacities are approximate maximums when storing traditional Bordeaux 750 ML bottles and may
include bulk storage. Many bottles differ in size and dimensions. As such, the actual number of bottles you may
be able to store may vary.
• When adding a bottle to the wine cooler, make sure there is no contact with the back interior of the cooler.
Ensure that no bottles are placed directly onto the electronic board of the control panel. Always place bottles on the
shelves only.
• To avoid damage to the shelves and ensure the cooler maintains a consistent temperature, do not overfill the
wine cooler.
SHELVES
To avoid damaging the door
compartment.
• The pull-out shelves allow bottles of wine to be viewed and removed
more
easily.
• For easy access to the storage bottles, you must pull the shelf
approximately
½
with a plastic post on each sides of the shelf track to prevent bottles from
falling.
• This unit's shelves may be adjusted to a range of
DOOR LOCK
The wine cooler comes with a lock and key combination. The keys are located inside the plastic bag that
contains the Owner's Manual. Insert the key into the lock and turn it counterclockwise to unlock the door.
To lock the door, insert the key into the lock and turn it clockwise making sure metal pin is engaged
completely. Remove the key and place it in a secure place for safekeeping.
DEFROSTING
The wine cooler defrosts automatically. The evaporator behind the rear wall of the unit automatically
defrosts and the condensate collects in the drainage channel behind the rear wall of the unit and flows
through the drainage hole into the drip tray by the compressor, where it evaporates.
12
UP button will increase the temperature by 1 degree.
DOWN button will decrease the temperature by 1 degree.
gasket,
ensure that the door is fully opened when pulling the shelves out of the rail
out of the rail compartment This unit was designed
W W W . V I N O T E M P . C O M
button first. You can then select the UP or DOWN button to
heights.