Publicité
BEFORE USING YOUR APPLIANCE
Remove all packing material before using your appliance.
IMPORTANT: Before connecting the unit to a power source, let it stand upright for approximately
24 hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
Clean the interior surface with lukewarm water and a soft cloth.
INSTALLATION OF YOUR APPLIANCE
This unit is designed for freestanding and built-in installation and indoor use only. Position the unit
•
in a dry and well-ventilated place. Avoid placing the cooler near any source of heat or moisture, or
in direct sunlight. Ambient temperature between 38-110°F is recommended in any setting.
For built-in installation, leave a ¼" (6.35mm) space on each side and at the top of the wine cooler
•
to ensure proper air circulation to cool the compressor and condenser. Also, be sure to not obstruct
the front exhaust vent with any objects as this may affect the unit from performing properly.
For freestanding installation, 6" of space at the back, 10-12" of space on each side, and unlimited
•
clearance at the top of the wine cooler are suggested to ensure proper air circulation to cool the
compressor and condenser. Do not place underneath a table, counter top, or anything of the sort as
this will not allow for proper air circulation.
Do not slide the unit into place.
•
Place the wine cooler on a level surface strong enough to support it when it is fully loaded. To level
•
the wine cooler, adjust the front leveling legs at the bottom of the wine cooler.
For best performance it is recommended that you install the appliance in a location with an ambient
•
temperature between 38-110° F. If the ambient temperature is above or below recommended
temperatures, the performance of the unit may be affected.
Plug the wine cooler into an exclusive, properly installed-grounded wall outlet.
•
INSTALLATION OF THE STAINLESS STEEL HANDLE
This wine cellar includes a stainless steel handle that
is not required to operate this unit. To install the handle,
please follow the below
NOTE: Door gasket must not be removed, detached or
altered as it may directly affect cooling performance.
Locate the handle (1) over the pins (3) of the door and
tighten the handle by screwing the Allen key grub screws (2).
10
INSTALLATION
instructions.
W W W . V I N O T E M P . C O M
Publicité
