Publicité
OPERATION
„ Turn on the sander and move it slowly over the workpiece.
„ Make successive passes in parallel lines, circles, or
crosswise movements.
„ Turn off the sander and wait until the sanding pad comes
to a complete stop before removing it from the workpiece.
Do not force. The weight of the unit supplies adequate pres-
sure, so let the sanding pad and sander do the work. Apply-
ing additional pressure slows the motor, rapidly wears the
sanding pad and greatly reduces sander speed. Excessive
pressure will overload the motor causing possible damage
from motor overheating and can result in inferior work. Any
finish or resin on wood may soften from the frictional heat.
Do not allow sanding on one spot too long as the sander's
rapid action may remove too much material, making the
surface uneven.
Extended periods of sanding may tend to overheat the mo-
tor and the tool may shut off. If this occurs, turn sander off
and wait until sanding pad comes to a complete stop, then
remove it from workpiece. Remove your hand from vent area,
remove the battery and remove the sandpaper. Empty the
dust bag if installed, then reinstall the clean dustbag. Rein-
stall the battery. With your hand removed from vent area, turn
sander on and run it free without a load to cool the motor.
VARIABLE SPEED DIAL
See Figure 7, page 10.
The variable speed dial allows sanding speed adjustment
from 1 (lowest speed) to 6 (highest speed). To increase
sanding speed, turn the dial to a higher setting. Turn dial to
a lower setting to decrease sanding speed.
MAINTENANCE
WARNING:
When servicing, use only identical replacement
parts. Use of any other parts could create a hazard
or cause product damage.
NOTE: ILLUSTRATIONS START ON PAGE 9 AFTER
FRENCH AND SPANISH LANGUAGE SECTIONS.
This product has a 90-Day Satisfaction Guarantee Policy, as well as a Three-year Limited
Warranty. For Warranty and Policy details, please go to powertools.ridgid.com
EMPTYING THE DUST BAG
See Figure 4, page 10.
For more efficient operation, empty the dust bag when it is no
more than half full. This will permit the air to flow through the
bag better. Always empty and clean the dust bag thoroughly
upon completion of a sanding operation and before placing
the sander in storage.
To empty the dust bag:
„ Remove the battery pack.
„ Turn the dust bag counterclockwise to the UNLOCK
„ Shake out the dust.
„ Reattach the dust bag to the sander by sliding the bag
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
or call (toll free) 1-866-539-1710.
7 - English
WARNING:
Collected sanding dust from sanding surface coat-
ings such as polyurethanes, linseed oil, etc. can
self-ignite in the sander dust bag or elsewhere
and cause fire. To reduce the risk of fire always
empty the dust bag frequently (10-15 minutes)
while sanding and never store or leave a sander
without totally emptying its dust bag. Also follow
the recommendations of coating manufacturers.
position to remove it from the sander.
on to the dust port and turning it clockwise until the bag
is in the LOCK position.
Publicité
