Publicité
UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging. If the device has been exposed to
drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water might
damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
FRONT PANEL
1. VOLUME LEVEL
Rotate to adjust the volume level for the inputs (CH1-CH5)
2. ZONE SELECTOR Z1-Z4
Press to switch the corresponding input signal to the desired zone (Z1- Z4)
3. STATUS INDICATORS
LED indicators for each zone.
4. MON BUTTONS
Press to switch the corresponding signal of the PA zone to the headphone output PHONES (14), output MONITOR (21) and
the line signal out MIX OUT (20)
5. VOLUME CONTROLS
Rotate to adjust the volume of each PA zone from zone 1 to zone 4
6. MODE
Press this button to switch between modes. (AUX, BT or CH5. Press and hold this button to disconnect BT)
7. AUX IN
3,5 mm jack to connect audio units
8. LED INDICATORS
Indicators that show which mode is current
9. LINK (stereo pairing)
Press this button to pair in BT mode
10. TREBLE AND BASS CONTROL
Rotate to adjust the Treble and Bass level from CH1 to CH5
11. GAIN CONTROL
Rotate to adjust the gain level from the CH1 to CH5
12. MUTE
Press this button for muting the corresponding input between CH1 to CH5. The led below the button will light up
13. HEADPHONE
3,5 mm jack input for headphone
14. PHONES LEVEL
Rotate to adjust volume of the connected headphone
15. MONITOR LEVEL
Rotate to adjust the volume of a monitor speaker which is connected to the terminals MONITOR
16. LED INDICATOR
Indicator that shows the signal of a monitor speaker which is connected to the terminals MONITOR
17. POWER INDICATOR
18. POWER SWITCH
Press this to power on/off the device
4
Publicité
