Publicité
selected press and hold the touchpad and you will hear the pump activate and see the vapor start filling the
dry cup. Once the dry cup is filled, pull the dry cup off the base, and inhale through the top.
Note: The Sipper works with most cartridges but not all cartridges.
AUTO MODE
Alternatively, you can press the touchpad 2 times to start the auto filling mode. The Sipper will run for 1 minute
continuously. Once you see the dry cup is full press the touchpad 1 time to stop the auto mode. Depending on the
cartridge your dry cup may fill before the 1 minute is up. Pro tip: This mode may be able to clear small clogs that
could occur in the cartridge or atomizer. If it takes more than 20 seconds, disable Auto Mode and use the included
dab tool as a poker to manually clear the clog.
CLEANING
Take apart the unit completely for cleaning. First, remove airflow valve and separate the two pieces. Next, remove
the atomizer/cartridge cover from the base of the unit and remove the airflow silicone. Lastly, remove the atomizer
or cartridge from the 510 connection, and unscrew 510 connection from the base.
Glass: Wipe the inside of the dry cup with an alcohol wipe until all the residue has been removed. Alternatively, you
could put the entire dry cup into 91% alcohol or glass cleaner and wait till the residue is dissolved.
Silicone Parts, 510 Connection, Base: Use an alcohol wipe or a cotton swab and 91% alcohol to clean off the build
up on all of the silicone parts and 510 connection. Use a cotton swab and 91% alcohol to clean any buildup beneath
the 510 connection. Gently wipe the Sipper base with isopropyl wipes to remove any excess residue. Do not
submerge the base in isopropyl or leave isopropyl on the base for an extended amount of time.
TROUBLESHOOTING
Dead Coil / No Connection: When the coil burns out or is not making a proper connection the light will flash red 3
times. Try removing and reinstalling the wax atomizer to reset connection. Otherwise, replace with a new wax
atomizer.
Low Battery Indicator: When the battery is less than 5% the light will flash red 8 times and the Sipper will power off.
Use the USB-C charging cable to recharge the Sipper until the touchpad light turns green.
For warranty servicing, contact us at PulsarShop.com
WARNINGS
Do not expose to extreme temperatures or direct sunlight. Do not drop the device or accessories. Do not drop or
submerge in any liquid. Do not modify the electronics in any way. This device is intended for adults only. Do not
sell or provide to minors. Keep all parts, concentrates, herbs, and liquids away from children and pets. This is not
a medical device and is not intended to diagnose, treat, mitigate, cure, or prevent any ailment, disease, or other
conditions. Consult a physician before use, especially if you suffer from heart disease or any other medical
condition, or if you are pregnant or breastfeeding. Failure to follow any of these instructions could result in
product damage, property damage, personal injury, and may void warranty. Visit
information.
PAGE 2
INSTRUCTION
MANUAL
PulsarShop.com
PulsarShop.com
for warranty
PU-0648-23
Publicité
