Pulsar 510 DL 5.0 Manuel D'instructions

SPECS
Size: 3.5" x 1.9" x 0.8" (89 x 48 x 21 mm)
Max Cart Size: 0.57" x 2.36" (14 x 62 mm)
Battery Capacity: 1000 mAh
Voltage: 1.8 - 4.2 V (1.8 V Pre-heat)
Charging: USB-C
Resistance: ≥ 0.8 Ω
KIT INCLUDES
1x Pulsar 510 DL 5.0 Battery
1x Bottom Magnetic Connector
POWER ON/OFF
Before using the DL 5.0, fully charge the device using a USB-C charging cable and a standard charging brick. You
will see the LED and screen turn on when the battery is charging. Allow the battery to fully charge before the first
use. When the battery indicator reaches 100%, the device is fully charged and can be unplugged. To power the
device on and off, quickly press the button 5 times. It enters a standby mode after 5 seconds. To wake the device
up, press the button on the bottom 1 time and the screen will turn on and show the current voltage, battery %, and
puff count. You can also pull from the mouthpiece and the device will be ready to vape.
INSERT CARTRIDGE
Remove the bottom magnetic connector and firmly screw in the 510-threaded cartridge of your choice. Insert the
cartridge into the device and ensure the bottom magnetic connector is properly connected.
PRE-HEATING
Quickly pull from the mouthpiece twice to activate the pre-heat function. You can also press the button on the
bottom 2 times to activate the pre-heat function. This function will be indicated by the Planet Ring Indicator
lighting up, when the Planet Ring Indicator is completely lit up, the pre-heat function is complete.
CHANGE VOLTAGE SETTINGS
Press and hold the power button to cycle through voltage settings (1.8 - 4.2 V) in increments of 0.1. Let go of the
button when it reaches your preferred setting. Or, you can click through the voltages by pressing the button once
to go up 0.1. If you pass your preferred setting and it stops at 4.2 V, you can press the power button again to start
the voltage back at 1.8 V.
CHARGING
Charging will be indicated by the battery's semicircle blinking and the lightning bolt flashing. When the device is
fully charged the battery indicator will read 100% and the flashing lightning icon will stop. When the battery life has
fully expired the light ring will flash red 10 times and enter standby mode to let you know it needs to be charged
before it's used again.
Puff Count Reset: Quickly press the button three times and hold the button on the third press.
Adjustable Airflow: You can adjust the airflow on the device by sliding open the airflow restriction valve at the
bottom of the device, next to the charging port.
PAGE 1
INSTRUCTION
MANUAL
VOLTAGE
BATTERY
PERCENTAGE
PUFF COUNT
PU-0782-24