Publicité
Installation by tightening the screws through front panel of order post
•
On the mounting surface for the order post, the M5 taps for the provided screws and the 1/4-
20UNC taps are located. Instead of the provided screws, two 1/4-20UNC screws can also be
used for the installation of the unit if procured locally. (Tightening torque: 2 N·m {1.48 lbs·ft})
The following is an installation example using the provided M5 screws.
1.
Attach the two brackets to the unit.
•
Remove the two M4 screws from the unit, and use the screw for the brackets. (Tightening
torque: 1.2 N·m {0.88 lbs·ft})
* Be sure not to leave screws removed, otherwise unintended noise may go through screw
hole, and the acoustic performance may be affected.
•
When the brackets are attached on each side with the positions shown in the illustration, it is
possible to align the height of the screws exposed out of the order post.
1/4-20UNC tap
M5 tap
All manuals and user guides at all-guides.com
Bracket
Remove the screws from the unit,
and tighten them onto the brackets.
Bracket
M5 tap
1/4-20UNC tap
17
Publicité
