Husqvarna S 138C Manuel D'utilisation page 16

• Examine the dethatcher equipment for damage
or cracks. Always replace a damaged dethatcher
equipment.
To replace the dethatcher equipment
WARNING:
when you do maintenance on the dethatcher
Troubleshooting
Problem Possible cause
The product does The power cord is not connected to a
not start. power source.
The power cord is not connected to the
product.
The motor brake handle is not pushed in
the direction of the handlebar.
The power cord is damaged.
Other errors.
Transportation
• For commercial transports special requirements on
package and labels must be obeyed.
• Make sure that you obey the regulations for
dangerous material when you prepare the product
for transport. Local regulations can apply.
• Attach the product during transport.
Storage
• Let the product become cool before storage.
• Keep the product where the ambient temperature is
between -10°C and 40°C.
• Keep the product in a locked area out of reach for
children and not approved persons.
• Clean the product and do a complete servicing
before you put the product in storage for a long time.
• Do the maintenance procedures given in this
operator's manual. Refer to
on page 15 .
16
Use protective gloves
Troubleshooting
Transportation, storage and disposal
Maintenance schedule
equipment. The dethatcher equipment is
very sharp and cuts can easily occur
1. Put the product on its right side. (Fig. 36)
2. Remove the 2 screws (A) and the dethatcher cover
(B). Push the dethatcher equipment (C) up and out
to remove it. (Fig. 37)
3. Push the new dethatcher equipment (C) into the
groove and down the hole. Attach the dethatcher
cover (B) and the 2 screws (A) (Fig. 38)
Solution
Connect the power cord to a power source.
Connect the power cord to the socket below the
handle.
Push the motor brake handle in the direction of the
handlebar.
Speak to an approved service agent.
• Do a complete servicing before long time storage.
Disposal
Symbols on the product or the packaging of the product
indicate that this product cannot be handled as domestic
waste. It must be submitted to an appropriate recycling
station for the recovery of electrical and electronic
equipment.
By ensuring that this product is taken care of correctly,
you can help to counteract the potential negative impact
on the environment and people that can otherwise
result through the incorrect waste management of this
product. For more detailed information about recycling
this product, contact your municipality, your domestic
waste service or the shop from where you purchased
the product.
(Fig. 39)
2368 - 003 - 27.09.2024