Publicité
PACKING LIST
Heater
•
•
Remote control
Instruction manual
•
Accessories pack 1 set:
•
− 2x support
− 8x metal screw for supports
ASSEMBLY INSTRUCTION
Unpack your package and find the heater together with the wall mounting accessories pack.
1.
Mark the positions of the four holes to be drilled on the wall, and Drill the holes with the drill bit. Make sure the distance between each holes
is same as the round holes on the brackets at back of the heater.
2.
Insert the plastic rails fitting into the holes.
3.
Insert the metal screws into the plastic rails.
4.
Lift the heater and aim the round holes on the brackets at back of the heater to the screws on the wall and slide the heater 10mm to the
right
5.
Make sure the distance between the bottom of the heater and the floor is no less than 10cm when the heater is installed
Rated voltage
220-240V~50Hz
Model
L mm
90-091
515
90-092
675
90-093
835
H mm
L1 mm
H1 mm
450
218
344
450
378
344
450
538
344
Publicité
