Télécharger Imprimer la page

Publicité

Liens rapides

Installation Instructions
PARTS LIST
Hood protector
Protège-capot
Mounting Clips (7)
Corps de pince (7)
Pins (7)
Goupille
(7)
Screws (7)
Vis (7)
Anti-abrasion pads- large (7)
Tampons anti-abrasion-grand (7)
Metal "L" brackets (7)
Supports métalliques en « L » (7)
Bumpons (6)
"D" Gasket
Joint d'étanchéité "D"
Surface cleaner (1)
Nettoyant de surface (1)
TOOLS AND SUPPLIES REQUIRED
Phillips screwdriver #2
Tape measure
Clean cloth or paper towel
OUTILS ET FOURNITURES NÉCESSAIRES
Tournevis cruciforme Phillips #2
Ruban à mesurer
Nettoyer le chiffon ou un essuie-tout
Page 1 of 3
Hood Protector
Nissan Armada 2017- up
INSTALLATION
 Ensure the vehicle is clean and completely dry before
installation.
 Use of the correct screwdriver will facilitate a trouble
free installation. Do not attempt to use #1 or smaller
Phillips screwdriver or any type of powered screwdriver.
CARE
Hand clean the protector using a mild soap and water
solution or plastic cleaner only.
Avoid automatic car-wash equipment where a brush
and/or soft cloth come in contact with the hood protector.
Touch-less style automatic car-wash equipment is less
likely to harm the air protector.
SERVICE
Periodically check to confirm the protector is securely
attached to the hood.
WARNINGS
Do not pull / push on the protector when opening / closing
the hood.
INSTALLATION
 Assurez-vous que le véhicule est propre et bien sèche
avant l'installation.
 L'utilisation du tournevis correct faciliter une installation
sans problème. Ne pas tenter d'utiliser un tournevis # 1 ou
petites Phillips ou tout autre type de tournevis électrique.
SOINS
Main nettoyer le protecteur à l'aide d'une solution douce
de savon et d'eau ou un nettoyant plastique uniquement.
Éviter les équipements automatiques de lavage où une
brosse ou un chiffon doux viennent en contact avec le
protecteur de capot. Équipement de lave-auto automatique
touch sans style est moins susceptible de nuire à la
protection de l'air.
SERVICE
Périodiquement vérifier pour confirmer le protecteur soit
solidement fixé à la hotte.
AVERTISSEMENTS
Ne pas tirer/pousser sur le protecteur lors de l'ouverture /
fermeture de la capote.
HD 13U17

Publicité

loading

Sommaire des Matières pour FORM FIT HD 13U17

  • Page 1 HD 13U17 Hood Protector Installation Instructions Nissan Armada 2017- up PARTS LIST INSTALLATION Hood protector  Ensure the vehicle is clean and completely dry before Protège-capot installation.  Use of the correct screwdriver will facilitate a trouble Mounting Clips (7) free installation.
  • Page 2 1. Install six (6) bumpons as shown in the diagram below. **Bumpons must be installed on the hood. If they are installed on the hood protector they will wear through the paint on the hood** Installez les six (6) bumpons comme le montre le schéma ci-dessous.
  • Page 3 6. Place a clip body over each of the three abrasion pads on the edge of the hood. Placer un corps de pince sur chacun des trois plots d'abrasion sur le bord de la hotte. 7. Insert a pin through the protector into each of the three clip bodies.