FORM FIT HD 10M09 Installation Instructions

FORM FIT
Installation Instructions
3 Large Bumpons
4 Plastic Expansion Plugs
4 3M Anti-Abrasion Film Pads
4 Clip Bodies
1. Be sure that the hood is clean and dry inside and out.
Install the bumpons on the hood as shown in illustration #1. Attention: The bumpons must be installed on the hood not on
2.
the protector!!!! If the bumpons are installed on protector, they will wear through the paint.
Open the hood of the vehicle. Remove and discard four (4) fasteners holding the hood seal in place as shown in Illustration #1. The
3.
first one is located 80mm off center of the vehicle, the second one 320mm off the center of the vehicle.
4. Install the protector. Make sure the mounting flanges on the protector are installed under the hood seal, and the protector is centered.
Install the four (4) plastic expansion plugs through the hood seal, through the protector and into the hole in the hood. Insert the #10 x
½ pan head sheet metal screws into the expansion plugs. See Illustration #1.
Note: Be sure to fully seat the plastic expansion plugs into the hole in the hood. The job of the #10 x ½ screw is to expand the legs of the
expansion plug into the hole; it will not draw the components together.
5. Peel and fold the anti-abrasion film pads in half over the edge of the hood. Place them underneath the four (4) outer holes on the
protector. See illustrations #1 & #2
a) Place a clip over each of the anti-abrasion film pads. See illustration #2
6.
b) Insert a pin through the protector and into each of the clips. See illustration #2
c) Insert the #6 x 5/8 screw through the L - bracket and into the clip. See illustration #2
d) Make sure all the components are well seated together and that the protector is centered on the hood. Tighten the screws into the
clips.
7. On some vehicles it may be necessary to adjust the hood bumpers and/or latch for proper clearance.
NOTE: Do not pull on the protector when opening or closing the hood.
Clean the protector with a either a mild soap/water solution or utilize a plastic cleaner. Do not use chemicals or solvents.
Periodically check to make sure the bumpons are in place and that the protector is secure. Avoid using automatic car washes.
420mm
100mm
Step #5
FORM FIT
Thank you for purchasing a
MADE IN CANADA
All manuals and user guides at all-guides.com
Hood Protector
4 L Brackets
4 Pins
4 # 6 x 5/8 Flat Head Screws
4 # 10 x ½ Pan Head Screws
Step 5.
420mm
100mm
80mm
320mm
Step #6a
plastic hood protector. Retain this sheet for care instructions and kit information.
Hyundai Elantra Touring 2009 -
1
1
Step 6a.
Step 6b.
Step 6c & 6d.
Step #6b
HD 10M09
Phillips Screwdriver # 2
Tape Measure
Protector
Hood
Hood Seal
Expansion Plug
#10 x ½ Screw
Step #6c & 6d
Rev0.150802