FORM FIT HD 13S14 Instructions D'installation

Installation Instructions
PARTS LIST
Hood protector installation tape measure
Hood protector
Large pedestals (5)
Small pedestals (2)
Pins (7)
Screws (7)
Anti-abrasion pads (7)
Small metal mounting bracket (2)
Large metal mounting brackets (5)
Surface cleaner (1)
Re-usable tape strips (1)
Pedestal centering template
TOOLS AND SUPPLIES REQUIRED
Long Shank Phillips Screwdriver #2
Masking Tape
Clean cloth or paper towel
All manuals and user guides at all-guides.com
Hood Protector
HD 13S14
Nissan Rogue 2014 - up
INSTALLATION

Make sure the vehicle is clean and completely dry before
installation.

This product uses a 3M adhesive that requires installation
and curing temperatures of 15° to 43°C (60° to 110°F) for 1
hr to develop maximum adhesion to the hood surface.
Failure to install this product at the proper temperature or
allow adequate curing time before use is not covered under
warranty.

Proper installation of the adhesive pedestal system
requires the use of a #2 Phillips screwdriver, preferably
with a long shaft. The shaft of the screwdriver needs to fit
through the hole in the pedestal. Use of the correct screw
driver will facilitate a trouble free installation. Do not
attempt to use #1 or smaller Phillips screwdriver or any
type of electric screwdriver.
1. Insert a pin through the hole in the hood protector installation tape
measure supplied and into one of the large adhesive pedestals.
2. Install one of the screws into the pedestal.
Locate center pedestal using installation tape
measure and/or the supplied centering template.
3. Using masking tape or repositionable tape strips supplied, dry fit
the large adhesive pedestal at the centre of the hood.
NOTE: The fingers incorporated on the leading edge of the
pedestal ensure the correct position relative to the hood edge.
When correctly positioned the fingers should contact the leading
edge of hood.

Use the installation tape measure to confirm center by
measuring to opposite corners of the hood and adjust pedestal
until both measurements are identical.
Tape measure is always located below the measuring
*
point
*
HD 13S14 Rev0.Dec22, 2017 Page 1 of 11