Briggs & Stratton VANGUARD Battery Charger - 3000W Manuel D'utilisation page 7

FCC (Class A) and IC Information
Compliance
FCC Compliant
Pursuant to part 15.21 of the FCC Rules, you are cautioned that changes or
modifications to the product not expressly approved by Briggs & Stratton could void
your authority to operate the product.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in an industrial installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Technical Specifications and Features
Ta = 25 °C (77 °F) unless specified differently.
Mains Side
Symbol, Condition, Value and Unit Information Table
Description Symbol
Supply Voltage Vin
Frequency f
Maximum Current per phase. Ifmax
Inrush Current -
Power Factor cosϕ
Minimum Power Pinmin
Maximum Power Pinmax
Battery Side
Symbol, Condition, Value and Unit Information Table
Description Symbol
Maximum output current |1
Output current ripple -
Standby current |a
Output voltage U
Operating range of Temperature ΔT
Sensor
Maximum power supplied Pmax
General Conditions
Symbol, Condition, Value and Unit Information Table
Description Symbol
Operating range of temperature ΔT
Maximum relative humidity RH
Efficiency η
Weight -
Enclosure class -
External fan class -
IC Information to User
This device complies with Industry Canada's license-exempt RSSs. Operation is subject
to the following two conditions:
1. This device may not cause interference; and
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
Test Condition Value and Range
- 110 - 230 ± 10%
- 50 - 60
P = Pmax 16
Vin=230Veff < 3
P = Pmax 0.98
End of charge - Standby < 5
P = Pmax 3.3
Test Condition Value and Range
Phase 1 60
I = I1 < 5%
Equipment turned off < 0,5
- 58.8 Maximum (controlled by the
Vanguard BMS)
- from -20 to +55
U = U1, I = I1 3000
Test Condition Value and Range
- from -20 °C (-4 °F) to +50 °C
(122 °F)
- 90%
At each operation condition ≥90%
With connecting cable 8
- IP65
- IP55
Unit
Veff
Hz
Aeff
A
-
W
kW
Unit
A
-
mA
-
°C
W
Unit
°C (°F)
-
-
kg
-
-
7