Adventure X-presso bi 2 Manuel D'utilisation page 24

The X-PRESSO BI 2 was tested in fligt equipped with Standard "ABS"
SUP'AIR harness (Attachment height of 42 cm. Front strap tightened 50%,
distance between the carabiners 42 cm).
The X-PRESSO BI 2 is delivered with a 3 risers system of 400 mm
length
in no trimmed configuration, and a trim system. A fourth A' branch is attached
by a scratch band to the A Branch for big ears manoeuver .
Be aware that trim grips can slip when grips are worn out.
Two models are available :
Foot launching :
The neutral position corresponds to the equal length of the three
branches. This is the safest attitude you must adopt for taking off, flight in
thermal or turbulences, approaching and landind.
The slow speed configuration (trims fully pulled) is to be used for
thermal flight in smooth conditions. This configuration reduces brake strength.
X-PRESSO BI 2 is delivered with rigid separators and can be equiped with
supple separators.
The fastest speed configuration (trims fully relased) can be used to
increase maximum speed in smooth conditions and to make inflation easier in
windy conditions.
Buggy launching :
These risers offer a reduced strength for trimming beetween
neutral and fully released position.
Taking off with a buggy must be done in released position of the trims
RISERS - TRIMS
LINES - SCHEMES
24
HARNESS