Publicité
4 Operation
First, open any one of the outlet valves at the outlet
of the water heater, then, open the inlet valve. The
water heater gets filled with water. When water
flows out of the outlet pipe it implies that the heat-
er has been filled fully with water, and the outlet
valve can be closed.
C
During normal operation, the inlet
valve shall be always kept open.
• Insert the supply plug into the socket.
• If the indicator lights up, the thermostat will au-
tomatically control the temperature. When the
water temperature inside the heater has reached
the set temperature, it will switch off automati-
cally, when the water temperature falls below the
set point the heater will be turned on automati-
cally to restore the heating.
1. Rotate the knob according to the marking on the
knob to increase or decrease the setting tem-
perature. In Low mode, the setting temperature
is about 30C°; In high mode, the setting tem-
perature is about 75C°; In Eco mode, the setting
temperature is about 55C°.
Electric Storage Water Heater / User Manual
2. In a power-on state,the machine is heating when
the indicator light is blue.The indicator light goes
out when the heating process is finished, in the
insulating state.
13 / EN
Publicité
