Publicité
PW 1080
1/2" IMPACT WRENCH 1080Nm 20V BRUSHLESS
PW 1081
REVERSE (COUNTER CLOCKWISE) OPERATION:
The electronic clutch has two different reverse modes: Full Reverse and Auto Break.
The Full Reverse mode is automatically activated when the direction switch is put into the reverse
position. No LEDs on the Electronic clutch control panel should be illuminated. This means that
the clutch is set to full reverse mode. When the trigger is pushed the tool will operate in reverse
for as long as you hold down the trigger.
The Auto Break function is engaged by pushing the button on the Electronic clutch control panel.
A red LED will illuminate in the third LED position to indicate that the Auto Break is engaged.
When the trigger is pushed the tool will start hammering in reverse. As soon as the bolt breaks
loose and there is no resistance the tool will immediately stop reverse motion. This feature is meant
for controlled loosening of lug nuts without backing fully off the stud. Uncontrolled spinning can
damage the treads on the end of the stud or bolt. To disengage break just push the button one
more time and the red LED will turn off. Your tool is again in the full reverse mode.
NOTICE: Both reverse functions only operate wffh the electronic clutch in the third speed position.
This feature is unavailable in speed one and two.
OPERATING TIPS
To install a socket, align the square drive with socket receiver and press on until locked securely in
place. To remove socket, pull the socket off while twisting back and forth to dislodge.
Caution: When removing socket or bits from tool, avoid contact with skin and use proper protective
gloves when grasping socket. Accessories may be hot after prolonged use.
Apply the power tool to the screw/nut only when it is switched off. Rotating tool inserts can slip off.
The torque depends on the impact duration. The maximum achieved torque results from the sum
of all individual torques achieved through impact. The longer the tool is engaged the higher the
accumulated torque value. Maximum torque is achieved in about 45 seconds. The actual achieved
tightening torque should always be checked with a torque wrench.
Publicité
