Publicité
PW 1080
1/2" IMPACT WRENCH 1080Nm 20V BRUSHLESS
PW 1081
4. Keep the tool off away from children and do not allow to be used by people who are not familiar
with the tool. Tools are dangerous in the hands of inexperienced.
5. Make sure the tools moving parts are not aligned or blocked, that it has not broken any parts
or any other condition that may affect the operation of the tool. In case of damage, take the tool
to a repair service before using it again. Many accidents are caused by poorly maintained tools.
6. Tools used for cutting, with sharp pieces that have had good maintenance, are less likely to
become blocked and are easier to control.
7. Use the tool, accessories and blades, etc. according to these instructions, taking into account
the working conditions and the work to be done. The use of the tool for operations other than
those provided can lead to dangerous situations.
PRECAUTIONS FOR USE
1. Do not use any other charger than the one specified by the manufacturer. A charger that fits to
a type of battery can cause a risk of fire when used with other types of batteries.
2. Do not use tools with batteries other than those specified. The use of any other type of battery
may create a risk of injury and fire.
3. If the batteries are not used, keep them away from other metal objects such as clips, coins, keys,
nails, screws or other small objects that can lead to a connection from one terminal to another.
Short-circuiting the tem,inals of a battery can cause bums or fire.
4. In bad conditions, liquid may be ejected from the battery; avoid any contact. In case of accidental
contact, flush with water. If the fluid comes into contact with eyes, seek medical assistance. The
ejected battery fluid may cause irritation or burns.
CARE AND MAINTENANCE
1. Repairs must be perfomied by a qualified expert, using only identical replacement parts. This will
ensure that the safety of the tool is maintained.
2. Unplug tool and charger from the wall outlet before cleaning.
Cleaning
1. Keep protection devices, air vents and the motor housing as clean (dust free) as possible. Clean
the tool with a clean cloth or clean with compressed air at low pressure.
2. We recommend cleaning the tool directly after each use.
3. Clean the tool regularly with a damp cloth and a little soap. Do not use any cleaner or detergent,
they can damage the plastic parts of the tool. Ensure that no water enters the tool.
Maintenance
1. Recharge the battery at least once a year to maintain battery life.
ENVIRONMENTAL PROTECTION
This device uses electronic components, so they should not be deposited with household garbage!
Please help by collaborating to protect resources and the environment. Dispose of these products
through relevant recycling services, if any. For questions on this matter, please contact your local
waste management or a specialized site.
BATTERY
CHARGING THE BATTERY PACK
1. Remove the battery pack from the handle by pressing the battery lock button downwards and
pulling the battery foiwards and off the base of the tool.
2. Check if the power voltage on the rating plate corresponds to the voltage available.
3. Slide the battery pack onto the battery charger. The red LED will illuminate to indicate that the
battery pack is being charged. When the charging process is finished, the red LED on the charging
base will turn off and the green LED will illuminate. It takes approximately 1 hour to fully recharge
an empty battery.
4. During charging, it is normal for the battery to warm slightly. If you cannot discharge the battery
check:
- That the electrical outlet has voltage.
Publicité
