Publicité
to the underside of the deck and the clippings
cannot be collected or discharged properly.
5) A higher cutting height shall be applied to new
WARNING: Stop the mower and remove the
battery pack before removing the grass bag.
NOTE: To ensure long and reliable service, perform
the following maintenance procedures regularly.
Check for obvious defects such as a loose,
dislodged or a damaged blade, loose fittings,
and worn or damaged components. Check that
the covers and guards are all undamaged and
are correctly attached to mower. Carry out any
necessary maintenance or repairs before operating
mower. If the mower should happen to fail despite
regular maintenance, please call our customer
helpline for advice.
BLADE SHARPENING
KEEP BLADE SHARP FOR BEST MOWER
PERFORMANCE.
WEAR PROPER EYE PROTECTION WHILE
REMOVING, SHARPENING, AND INSTALLING
BLADE. ENSURE THAT BATTERY PACK IS REMOVED.
Sharpening the blade twice during a mowing season
is usually sufficient under normal circumstances.
Sand causes the blade to dull quickly. If your lawn
has sandy soil, more frequent sharpening may be
required.
REPLACE BENT OR DAMAGED BLADE
IMMEDIATELY.
WHEN SHARPENING THE BLADE:
1. Make sure blade remains balanced.
2. Sharpen blade at the original cutting angle.
3. Sharpen cutting edges on both ends of blade,
removing equal amounts of material from both ends.
NOTE:
Be sure the mower is turned off and remove the
battery pack.
TO SHARPEN BLADE IN A VISE (SEE Fig. K1)
1. Be sure the bail handle is released, the blade
has stopped and the battery pack removed before
removing the blade.
2. Remove blade from mower. See instructions for
removing and attaching blade.
3. Secure blade K1-1 in a vise K1-2.
4. Wear safety glasses and be careful not to cut
yourself.
5. Carefully file the cutting edges of the blade with a
fine tooth file K1-3 or sharpening stone.
6. Check balance of blade. See instructions for blade
balancing.
7. Replace blade on mower and tighten securely.
Refer to instructions below.
EN
12
or thick grass and it will extend the battery
duration.
MAINTENANCE
MAINTENANCE
BLADE BALANCING (SEE Fig. K2)
Check balance of blade by placing center hole in
blade K2-1 over a nail or screwdriver shank K2-2,
clamped horizontally in a vise K2-3. If either end of
the blade rotates downward, file that end. Blade is
properly balanced when neither end drops.
BLADE MAINTENANCE (SEE FIG. L)
Replace your mower blade after 50 hours of mowing
or 2 years of use, whichever comes first.
Follow these procedures to remove and replace the
Blade. You will need garden gloves (not provided) and
a spanner wrench (not provided) to remove the Blade.
Make sure the battery is not installed. Wedge a block
of wood between the blade and the mower deck to
prevent the blade from turning and unscrew the blade
bolt counter-clockwise using a spanner wrench, and
then remove the blade.
To re-assemble, position the blade with the cutting
edges towards the ground. Then securely tighten the
blade bolt.
STORAGE (SEE Fig. J1, J2)
Stop the mower and always remove the battery pack.
Clean the exterior of the machine thoroughly using
a soft brush and cloth. Do not use water, solvents
or polishes. Remove all grass and debris, especially
from the ventilation slots.
Turn the machine on its side and clean the blade
area. If grass cuttings are compacted in the blade
area, remove with a wooden or plastic implement.
Store the machine in a dry place. Do not place other
objects on top of the machine.
To aid storage, release the handle knobs, and fold the
upper handle as shown in Fig. J1 & J2.
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0 °C~45 °C.
The recommended ambient temperature range for
the charging system during charging is 0 °C~40 °C.
Details regarding safe disposal of used batteries
At the end of the life of the appliance, remove the
battery pack safely before disposing of the appliance.
Do not throw batteries away or throw them in the
normal trash can. Also do not dispose of the battery
with the machine. Remove the used battery pack
from the appliance and dispose of it at the nearest
or convenient dedicated recycling facility. If in
doubt, consult your local environmental protection
department. Batteries may enter water cycle if
disposed improperly, which can be hazardous for
ecosystem. Do not dispose of waste batteries as
unsorted municipal waste.
Publicité
