Eaton Tripp Lite Serie Manuel Du Propriétaire page 3

Installation
Prior to use, place/position the switch:
• On a level surface that can support the weight of the switch (and any
other items that need to be considered)
• With a minimum of 25 mm (approx. 1 inch) of clearance on the top and
sides for adequate ventilation
• Away from electric-noise sources: radios, transmitters, broadband
amplifiers, etc.
• Where it cannot be affected by excessive moisture
Ports
All ports on the switch support Auto-MDI/MDI-X functionality. You can use
straight or crossover UTP/STP cables to connect the RJ45 ports to PCs,
routers, hubs and other switches.
Ports 1 – 8: 10/100/1000 Mbps ports, IEEE 802.3af/at compliant, providing
a maximum of 30 watts to connected PoE devices. The total PoE budget for
this switch is 60 watt. The per-port average power distribution is 7.5 watts.
• Port 1: The designated uplink port can be used the same way as any of
the other ports. However, this port remains accessible from all other
ports when port isolation (VLAN mode 1 or 2) is active.
3