Publicité
you can press the standby button to enter the comfort mode.
NOTES: In case of a power failure, the unit will store only the set-
tings, temperature and operating mode. When the power is restored,
the clock must be reset in order to use the Program mode normally.
Press OK to select one of the modes: Comfort
2/ The Program and Pilot Wire modes are mutually exclusive. When
the unit is in Program mode, press the
switch from Program mode to Pilot Wire mode.
When the unit is operating in the Pilot Wire mode, press
ton for 3 seconds to switch from Pilot Wire mode to Program mode.
The interfaces of the Program and Pilot Wire modes are as follows:
Program mode
NOTE: For Program Mode, the setting and mode selection are se-
parate. To set the program mode, press
menu and select the program mode setting, then press OK to display
the setting interface. For details, see subchapter 3.5 «Setting the
Program Mode».
Pilot wire mode
- Press the OK button to select the Program
or Pilot Wire mode
external control (for France only).
- For countries other than France, if you choose the Pilot Wire mode,
the unit will operate in the Comfort mode by default.
- When the interface is in Program mode, press
ton for 3 seconds to switch from Program mode to Pilot wire mode.
- When the external controller is programmed, the display will show:
pilot control mode setting
Comfort mode
Comfort mode
or Pilot Wire
. In Pilot Wire mode, select the mode via the
Comfort mode
Eco mode
Frost protection
Standby mode
/ Frost Protection
button for 3 seconds to
Pilot wire mode
to display the setting
Icone display
26
/ ECO
/ Program
the but-
and hold the but-
Publicité
