Publicité
Operation
Check before switching on!
Check the safe condition of the device:
– Check whether there are any visible defects.
– Check whether all parts of the product are firmly
attached.
– Make sure that the On/Off switch is not locked.
Switching on/off
– Switching on: Set the On/Off switch (2) to posi-
tion [1].
– Switching off: Set the On/Off switch (2) to posi-
tion [0].
Electronic speed control
The product is equipped with electronic speed con-
trol.
The speed can be steplessly controlled (speed range:
► Technical data – p. 26).
– Turning the speed controller (1) towards [Max]
increases the speed.
– Turning the speed controller (1) towards [1]
reduces the speed.
NOTICE! Risk of product damage! The
motor can overheat if continuously run
under heavy load and at low speeds. If the
motor has been run at elevated speed, allow
it to cool by idling.
Sanding
– Clamp in the workpiece or hold it firmly.
– Switch on the product and press it against the sur-
face to be sanded applying even pressure.
DANGER! Risk of death through electric
shock! Only use the product for dry sand-
ing.
WARNING! Danger of fire! Do not use a
dust container when sanding metal! Hot
metal particles can ignite the material of the
container.
Note: When working on vertical surfaces,
hold the product such that the dust container
faces downwards.
Fault/malfunction
Product not running.
Sanding power too low.
If you can't fix the fault yourself, contact your nearest
vendor. Please be aware that any improper repairs
will also invalidate the warranty and additional costs
may be incurred.
Cleaning
Cleaning at a glance
Regularly, depending on the conditions of use
What?
Clean dust from the mo-
tor's ventilation slots.
Clean the device.
Empty the dust container
► P. 4, fig. 4
– Pull the dust collector (7) fully away from the rear
► P. 4, fig. 5
– Press the unlock push butons (8) and keep them
– Remove the lid (9) from the dust collector.
► P. 4, fig. 6
– Remove the filter mat (10).
– Empty the dust container.
– Re-install the dust container in reverse order. Pay
Troubleshooting
If something doesn't work...
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the ven-
dor. You will save yourself a lot of trouble and possibly
money too.
Cause
Device defective?
Is the sanding disc not suitable for
material?
Sanding disc worn out?
Disposal
Disposal of the appliance
A crossed-out wheelie bin icon means: Bat-
teries and rechargeable batteries, electrical
or electronic devices must not be disposed of
with household waste. They may contain
substances that are harmful to the environ-
ment and human health.
Note: Excessive imprints do not lead to
increased sanding performance, but leads
to increased wear of the product and the
sanding disc.
DANGER! Risk of injury! Before all work
on the device, disconnect the mains plug.
Note: Always empty the dust collector to
ensure optimum dust collection.
of the device.
pressed.
attention to the correct position of the filter mat.
DANGER! Caution, risk of injury!
Improper repairs can result in the product
functioning unsafely. This endangers your-
self and your environment.
Remedy
Contact service partner.
Replace the sanding disc (► Attach
the sanding disc – p. 24).
GB
How?
Use a vacuum cleaner,
brush or paintbrush.
Wipe the device with a
slightly damp cloth.
25
Publicité
