Publicité
When working with tools that cause consid-
erable dust, wear a dust protection mask.
Wear tight fitting clothes when working with
the device.
If you have long hair, cover or wear a hair
net.
Your machine at a glance
Note: The actual appearance of your prod-
uct may differ from the illustrations.
► P. 3, fig. 1
1. Battery pack (not included in the scope of deliv-
ery)
2. Rotational speed controller
3. On-Off switch
4. Additional hand grip
5. Protective hood for grinding
6. Abrading disc (not included in the scope of deliv-
ery)
7. Tensioning lever for protective hood
8. Locking button for spindle
► P. 3, fig. 2
9. Display for remaining capacity
10. Push button for capacity display
11. Locking button
12. Control lights
13. Battery charger (not included in the scope of
delivery)
What is included
• Cordless angle grinder
Dimensions
D
115 mm
d
D
b
115 mm
D
75 mm
d
b
D
Fitting the abrading disc
DANGER! Risk of injury! Never use dam-
aged abrading discs. Always check the
abrading disc for cracks or other damage
before fitting it.
Use only abrading discs whose permitted
rotational speed is at least as high as the
idling speed of the appliance (► Technical
data – p. 43).
b
d
6 mm
22,2 mm
—
—
30 mm
M14
• Protective hood for grinding
• Additional hand grip
• Face pin wrench for fitting abrading disc
• Instructions for use
Fitting
Fit the additional hand grip
► P. 4, fig. 5
The additional handle can be attached on the left [1],
at the top [2] or on the right [3] of the product.
– Screw the additional hand grip firmly into the
threaded hole on the appliance.
Permissible grinding tools
• The permissible maximum rpm or cutting speed of
the abrasive bodies used must comply with the
details in the table below.
• Therefore please observe the permissible rpm or
peripheral speed on the label of the abrasive
body.
• Always use the intermediate layers enclosed with
the abrasive bodies: they are positioned between
the abrasive body and the clamping flange and
must be at least the same size as the contact sur-
faces of the flanges.
• When using abrasive bodies with threaded
inserts, it must be ensured that the end of the
spindle never touches the perforated plate of the
grinding tool (spindle length: ► Technical data –
p. 43).
• Abrasive bodies with threaded insert must be able
to be screwed onto the grinding spindle far
enough that they firmly fit the grinding spindle
flange at the end of the grinding spindle thread.
Max. rpm
-1
11000 min
-1
11000 min
-1
12000 min
WARNING! Risk of injury! The permitted
diameter for the abrading disc must always
be complied with (► Technical data – p. 43).
CAUTION! Risk of injury! Use only abrad-
ing discs which are permitted for the material
being worked with.
► P. 4, fig. 6
GB
max. cutting speed
80 m/s
80 m/s
45 m/s
41
Publicité
