Publicité
The distance per charge
becomes short (Note:
performance of the bike
battery
is
directly
related to weight of the
rider
and
any
baggage/load / wind /
road
/
constant
braking ).
After
plugging
the
power outlet, no charger
indicator LCDis lit.
After charging over 4-5
hours,
the
charger
indicator LCD is still red,
while the battery is still
above not full (Note: it is
very important to charge
your
bike
strictly
according
to
this
instruction
stated
in
Chapter 7, to avoid any
trouble
and
damage
occurred to your bike.
There is no speed/KM
show on the LCD
sensor
is too far away from the magnetic
ring on the B.B. axle; 5) the
connection between the sensor and
the controller is loosen or not
connected well.
1) charging time is not enough; 2) the
environment temperature is so low
that it affects the battery working. 3)
frequently going uphill, or riding with
head wind, or on poor
condition, 4) the tyres have low
pressure
(to
be
frequently braking and starting. 6)
battery has been stored without
using for quite a long time.
1) trouble from the power outlet;
2) poor contact between charger
input plug and power outlet;
3) the temperature is too low.
1) environment temperature is 40°C
and above.
2) environment temperature is under
0°C.
3) failed to charge bike after riding,
resulting in over discharge.
4) the output voltage is too low to
charge the battery.
The magnetic ball point on the wheel
spoke is in too far away distance from
the wheel speed sensor (fixed to
frame chain stay or front fork), which
make the sensor cannot get any
signals of the revolving wheel.
care, without braking; 3) open the battery
pack top, and check if the fuse is broken. If
yes, please visit your vendor or authorized
service for installing a new fuse; 4) adjusting
the distance between the magnetic ring and
the sensor, to make sure the distance is
within 3mm; 5) fix tight the connection
between the sensor and the controller.
1) please charge the battery according the
instruction (chapter 7.3); 2) in winter or
under 0°C, you'd better store the battery
inside the house; 3) it will be normal if the
road
riding conditions are improved as regular; 4)
pump the tyres and ensure tyres are fully
inflated);
5)
inflated to 45psi for your bike; 5) it becomes
normal when the riding situation will be
better. No worry about such a trouble; 6)
make regular charging according to this
instruction manual (refer to Chapter 6.3) If
the above has no effect, please contact your
vendor or authorized service.
1) check and repair the power outlet.
2) check and insert the power outlet tightly.
3) charge it in house.
If the above has no effect, please contact
your vendor or authorized service
1) charge the battery in an area under 40°C,
or according to this instruction chapter 7;
2). charge the battery inside the house, or
according to this instruction chapter 7;
3) please well maintain the battery according
to the Chapter 6.3 to avoid natural
over-discharge;
4) no charging when the power supply is
lower than 100V.
If the above has no effect, please contact
your vendor or authorized service.
Check the distance between the magnetic ball
point and the wheel speed sensor, and make
sure the distance should within 5mm.
17/38
Publicité
