Publicité
8. Using and maintaining the electric motor
8.1 Our intelligent e-bikes are programmed to start with the electric assistance after rotation of the chain
wheel.
8.2 Do not use the bike in flood waters or thunderstorm. Do not immerse the electric parts in water.
Otherwise, the electric components may be damaged.
8.3 Avoid any impact towards the motor, otherwise, the casting alloy aluminum cover and body may
break.
8.4 Make regular checks on the screws on both sides of the motor; fasten them even if they are just a
little bit loose.
8.5 It is necessary to check the cable connection to the motor.
9.Maintaining the controller
For our electric bikes the controller is usually equipped inside the battery pack holder.
It is very important to take care of this electronic component, according to the following guideline:
9.1 Pay attention to protect from ingress of water and immersion in water, which may damage the
controller.
Note: If you think water may have got into the control box, please switch off the power immediately and
pedal without electric assistance. You can pedal with electric assistance as soon as the controller has dried
out.
9.2
Pay attention to protect from any strong shaking and punching, which may damage this controller
9.3
The controller should be used in normal working temperature range from -15°C to +40°C
Warning:
or adjust the controller will void the warranty. Please ask your local dealer or authorized service specialist
to repair your bike.
10. Simple trouble shooting
The information below is for purpose of explanation, not as a recommendation for user to carry out repair.
Any remedy outlined must be carried out by a competent person who is aware of the safety issues and
sufficiently familiar with electrical maintenance.
Trouble Description
After the main battery
switched on, the motor
does
not
generate
assistance
when
pedaling.
Do not open the controller box. Any attempt to open the controller box, modify
Possible Causes
1)the
motor
cable
connection joint) is loose; 2) brake
lever did not return well, which keeps
the switch in "power off" position; 3)
battery fuse is broken; 4) the speed
(waterproof
First of all, please check the battery if it is
empty. If yes, charge the battery immediately.
1) check if the connection is securely fixed. If
loose, joint them tightly. 2) make the brake
lever come back to its normal position with
Trouble shooting
16/38
Publicité
