Publicité
INSTALLATION INSTRUCTIONS
Do not install in the following places:
1. A place that contains mineral oil, kitchens with atmospheres saturated with oil and steam (may cause degradation and
water condensation), or other resinous products.
2. A place with corrosive gases such as sulphuric acid gas or other gasses that create a corrosive atmosphere that
damages copper tubing, brazed joints or aluminum heat exchangers.
3. Locations where machines or equipment emit electromagnetic waves that can lead to operational malfunction of the
control system.
4. Locations where possible leakage of combustible gases may occur, suspended carbon fibers, or other atomized
combustible particles where the accumulation of which will lead to fires.
5. Locations where small animals inhabit, whose behavior damages the inner electrical components and may cause faults,
fire, etc.
6. Coastal locations with high salinity.
7. Locations known for drastic variation in supply voltages.
ATTENTION
This equipment is designed for use with R410A only. Any other type of refrigerant will cause the machine not to run.
• The connection kit handles (total of 4) should be used to lift or carry the connection kit. Do not handle the kit by any
other means as damage can occur to the pipe connections.
• Refer to the installation guide regarding the proper installation for each connection kit.
Moving and scrapping the air conditioner
• When moving, to disassemble and re-install the air conditioning, please contact your dealer for technical support.
• In the composition material of air conditioning, the content of lead, mercury, hexavalent chromium, polybrominated
biphenyls and polybrominated diphenyl ethers are not more than 0.1% (mass fraction) and cadmium is not more than
0.01% (mass fraction).
• Please recycle the refrigerant before scrapping, moving, setting and repairing the air conditioning; for the air
conditioning scrapping, should be dealt with by the qualified enterprises.
31-5000593 Rev. 0
7
Publicité
