Publicité
INSTALLATION INSTRUCTIONS
1. Pre-installation
The installation location selected shall meet the following conditions and be approved by users:
• Mounting structure and hardware shall be sufficient to withstand the weight of the connection kit.
• The connection kit is installed plumb and level.
• Ensure that there is enough space for installation and maintenance.
• There is space for inspection on the side and top of the electric box.
• The length of piping between the indoor and outdoor units shall be within specified limits (referring to the specification
attached to the outdoor unit).
• Select installation locations where noise will not be a problem for the user. Places with low noise requirements such as
bedrooms, drawing rooms, meeting rooms, offices, etc. should be avoided.
Note:
• The electrical box can be changed as shown in "3. Connection Kit Installation" .
• A noise may be emitted by the connection kit as a result of control during operation or stopping of an indoor unit. If it is
installed in the ceiling where it is exposed, take adequate precautions with the installation location.
• Inspect whether the installation location can sufficiently withstand the weight of connection kit and set the hoisting
bolts by reinforcing the beam if necessary. Use hoisting bolts in installation (referring to "2. Preparation Before
Installation" ).
• Install the power wiring and power line of the connection kit more than 39-13/32in. away from TV and radio to prevent
the image clutter and noise. There may be noise even if it is more than 39-13/32in. according to the different waves.
Front View
Min 7-7/8"
Front View
10
Wall Mounted (in.)
Ceiling Mounted (in.)
Min 7-7/8"
Min 7-7/8"
Top View
Side View
Min 7-7/8"
Min 2"
Min 11-3/4"
31-5000593 Rev. 0
Publicité
