Publicité
INSTALLATION INSTRUCTIONS
2. Preparation before installation (cont)
See the Fig.1 & Fig.2 to install the lifting bolts and
hoisting tools.
• Use the lifting bolts with the size of M8~M10
• Press insert for new settings. Press hole in
anchor if set. Ensure that it can sufficiently
withstand the weight of the connection kit
before installation.
3. Installation of Connection Kit
Use parts and components specified for installing the installation components.
(1) Change the installation direction of electric box according to requirements following the steps below; (see Fig.1)
Remove the cover of the electrical box; (2 screws)
1
Remove the electrical box; (2 screws)
2
Remove the top plate; (4 screws)
3
Change the outgoing direction of wiring (electric valve coil) between the equipment and the electrical box;
4
Install the electrical box;
5
Rotate 180° to install the top plate;
6
Install the cover of the electrical box.
7
31-5000593 Rev. 0
Thick Cement Plate
Mounting
Brackets
Less than 39-13/32"
NOTE: All the parts in the figure are purchased locally
④
Electrical Appliance Removal
④
Foundation Bolt
Long Nuts or
Connection Kit
Turnbuckle
Lifting Bolt
Less than 39-13/32"
Fig. 2
Fig. 1
13
Publicité
