Publicité
Connecting to Network
EN
Connecting Majority Bard with your network
Firstly, the device asks to keep network connected. To control the device in all
operating modes via the app, select 'YES' to confirm. If choosing 'NO,' while in
Standby Mode it is not possible to control the device from the app you can only do so
in AUX IN, FM, DAB operating modes.
Note: The power consumption in Standby Mode will be higher when the network
connection is On.
Once you confirmed your selection, a list of WIFI networks found available at your
location will then be displayed on the radio screen. Select from the list your network to
connect Majority Bard radio with it using one of the following methods:
Push button: The radio prompts you to press the connect button on your internet
•
router. Once activated, Bard radio scans for a ready Push Button network
available and connects.
Pin button: The radio generates an 8-digit code number which you enter into
•
your wireless router, access point, or an external registrar.
Skip WPS: Enter key as for a standard encrypted network. To enter the network
•
key, use the dial knob (Ref.6) or the direction buttons on the remote control to
move the cursor through the characters and press OK to confirm. As each
character is selected, the key is built up near the top of the display.
There are three options accessible by tuning the navigate dial knob (Ref.6) back
before the first characters – Backspace, OK and Cancel.
Note: For more information on setting up a WPS encrypted network, see your WPS
router's instructions.
Once the key has been entered Bard radio will search and connect to your network.
Bard radio will on its screen the status connected if the set-up has been successfully
completed. If connecting with your network using this method fails, it returns to the
previous screen to try again. Once completed, press OK to quit the setup wizard.
8
Publicité
