Publicité
FM Radio
EN
FM Radio
FM radio mode receives analogue radio from the FM band and displays RDS (Radio
Data System) information about the station and broadcast if available.
To find a station, press OK. The frequency display starts to run up as the device scans
the FM band. Alternatively, you can tune manually by turning the NAVIGATE knob.
Now playing information
While the stream is playing, the screen shows its frequency. If RDS information is
available such as station name, programme name, track title and contact details these
will also be visible. If there is no information available, on the radio display you will
only see the radio station frequency. Stereo broadcasts are indicated with an icon at
the top of the screen, to view further information about the broadcast, press INFO
button (Rem.21).
Each time you press INFO button, another set of information is displayed, cycling
through RDS text, further RDS text (station/programme type), frequency and today's
date.
Presets – 40 presets available, see page 9.
FM Settings Scan settings
By default, FM scans stop at any available station. This may result in a poor signal-to-
noise ratio (hiss) from weak stations. To stop at radio stations with good signal
strength only change the scan settings to 'Strong station only,' select 'Yes' to confirm.
Audio settings
All stereo stations are reproduced in stereo. For weak stations, this may result in a
poor signal-to-noise ratio (hiss). To play weak stations in mono, select FM weak
reception: 'Listen in mono only' and then YES to confirm.
17
Publicité
