Publicité
Light switch
CAUTION
Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
NOTE:
To prevent the battery power consumption caused
by forgetting to turn off the LED light, the light goes
off automatically in about 15 minutes.
11. Tightening mode selector function (Fig. 12)
CAUTION
Do not subject the switch panel to shock or
damage.
Select high/low mode and single/continuous
mode while the trigger switch is released. Failure
to do so could result in malfunction.
High/Low
Single/
indicator
Continuous
lamp
indicator
lamp
Fig. 11
Single/
High/Low
Continuous
selector
selector
switch
switch
Fig. 12
(1) High/Low selector switch
The rotation speed changes in 4 steps (500 1,200
2,000 2,600/min) each time the high/low selector
switch is pressed.
(2) Single/Continuous selector switch
The tightening torque can be adjusted according to
the work by changing the tightening mode using the
single/continuous selector switch and the high/low
selector switch on the side of the impact driver.
When the forward/reverse button is set to reverse,
the high/low mode and single/continuous mode are
set to "High" and "Continuous" respectively,
regardless of the indicators on the switch panel.
The mode switches between single and continuous
mode each time the single/continuous selector
switch is pressed.
In single mode, after the trigger switch has been
pulled to start operation, bolt-tightening stops
automatically after 1 to 4 tightenings.
In continuous mode, when the trigger switch is
pulled to start operation, bolt-tightening continues
(without stopping automatically).
NOTE:
The appropriate mode differs depending on the
screw and the material being screwed. Drive in a
few test screws and adjust the mode setting
accordingly.
The high/low and single/continuous selector
switches can only be set after the battery has been
installed in the driver and the trigger switch has been
pulled once.
English
15
Publicité
