Publicité
Protection dimension
The following illustrations demonstrate the dimensions of the zones of protection relative to the coverage
provided by the whole product.
Back
220
S/M
minimum zone
of protection
WS/Torso
Chest
Positioning of Leatt ® protection range
No single size of body protection can accommodate all body dimensions because of variation in height and shape.
In addition, Leatt ® impact protectors can only provide the maximum achievable level of protection when they
are correctly positioned and adequately secured on the wearer. Where fitted, the back, chest and limb impact
protector components are in fixed positions within the Back Protector and Body Protector, which should always be
of a snug fit to the body. In particular users should avoid choosing too big a protector because of the potential of
interference with the helmet that, should it occur, can result in a dangerous riding condition. If the primary impact
protector components do not correctly fit and cover the following areas, an alternative size may be required:
Back protector: Back protectors should be located centrally along the line of the spine, with the widest part of
the back protector extending over the scapulae (shoulder blades) and with the lower edge of the back protector
ending as close to the base of the spine as is comfortable.
Adjustment
Before completely zipping the garment closed, ensure that the back protector is in the correct position. When
worn with the user's safety helmet and a Leatt ® Brace, the protector should allow the full range of normal head
and neck movements (i.e.: looking up, looking down and looking side-to-side, such as when performing an over-
the-shoulder check); the protector, Leatt ® Brace and the helmet only coming into contact with each other as
the full range of normal movement is reached. With your Leatt ® protectors in place, check that you are able to.
Copyright © 2023, Leatt ® Corporation
238
L/XL
Protected zones in shoulder
to waist measurement
Size
S
Height
160-166
Chest
80-90
WS/Torso
46-50
260
XXL
*mm
M
L
166-172
172-178
90-100
100-110
46-50
51-54
Size range
3DF Protectors are
available in the following
sizes [cm]:
Use the following
pictogram to identify the
measurements provided.
Back
XL
XXL
178-184
184-196
110-120
120-130
51-54
55-59
GB
5
Publicité
