Publicité
Chest
Back
220
218
3DF-031-A
S/M
Shoulder
Elbow
198
3DF-016-L/R
3DF-016-L/R
WS/Torso
Chest
Positioning of Leatt ® protection range
No single size of body protection can accommodate all body dimensions because of variation in height and
shape. In addition, Leatt ® impact protectors can only provide the maximum achievable level of protection when
they are correctly positioned and adequately secured on the wearer. Where fitted, the back, chest and limb
impact protector components are in fixed positions within the Body Vest and Body Protector, which should
always be of a snug fit to the body. In particular users should avoid choosing too big a protector because of
the potential of interference with the helmet that, should it occur, can result in a dangerous riding condition. If
the primary impact protector components do not correctly fit and cover the following areas, an alternative size
may be required:
Back protector: Back protectors should be located centrally along the line of the spine, with the widest part of
the back protector extending over the scapulae (shoulder blades) and with the lower edge of the back protector
ending as close to the base of the spine as is comfortable.
Chest protector: Chest protectors should be positioned centrally along the vertical line of the sternum
(breastbone).
Shoulder protectors: Position from halfway between the shoulder point and neck, down onto the upper arm;
symmetrically, or biased to the front to give more frontal protection.
Elbow and forearm protectors
Position centrally on the elbow and along the line of the ulna (forearm) bone to the little finger.
Adjustment
Unfasten the waist straps and place the Leatt ® Protector over your head, ensuring that it is in the correct
orientation with the shorter chest plate to the front. Loop the straps into the locks molded into each side of the
protector and adjust the straps to a snug fit. When correctly-adjusted and worn with the user's safety helmet
and a Leatt ® Brace, the protector should allow the full range of normal head and neck movements (i.e.: looking
up, looking down and looking side-to-side, such as when performing an over-the-shoulder check); the protector,
Leatt ® Brace and the helmet only coming into contact with each other as the full range of normal movement is
reached. With your Leatt ® protectors in place, check that you are able to.
Copyright © 2023, Leatt ® Corporation
238
XXL
L/XL
minimum zone
of protection
225
Protected zones in shoulder
to waist measurement
Size range
3DF Protectors are available in the following sizes [cm]:
Use the following pictogram to identify the measurements provided.
Size
S
Height
160-166
Chest
80-90
WS/Torso
46-50
260
*mm
Chest
M
L
166-172
172-178
90-100
100-110
46-50
51-54
Elbow
Back
Shoulder
XL
XXL
178-184
184-196
110-120
120-130
51-54
55-59
GB
5
Publicité
