Publicité
Leatt
®
Corporation's personal protective equipment is not designed or intended to protect a
wearer against serious bodily injuries caused by hard collisions or crashes. Protective equipment
such as stone shields offer protection only against lofted stones or debris. Protective equipment
such as back or lumbar protectors do not protect against spinal injury. No protective equipment
can protect the wearer from all foreseeable impacts.
Testing and Approval
The Leatt® Body Protector 3DF Airfit Lite EVO has been tested against the manufacturer's specifications
and EU Type – Examination certification has been issued by RICOTEST Via Tione, 9 - 37010 Pastrengo (VR),
European Notified Body No. 0498. It is CE marked to denote compliance with the Personal Protective
Equipment Regulation (EU) 2016/425.
The following European Standards have been used in the evaluation of this product:
- EN 1621-1:2012 – "Motorcyclists' protective clothing against mechanical impact - Part 1: Motorcyclists'
limb joint impact protectors."
- EN 1621-2:2014 – "Motorcyclists' protective clothing against mechanical impact - Part 2: Motorcyclists'
back protectors"
- EN 1621-3:2018 – "Motorcyclists' protective clothing against mechanical impact - Part 3: Motorcyclists'
chest protectors"
- EN ISO 13688:2013 – "Protective clothing - General requirements"
Note: To view the Declaration of Conformity to PPE Regulation (EU) 2016/425 please navigate to leatt.com
and select the DOCUMENTS tab on your product's page.
Protection provided
Protector CE certified to PPE Regulation 2016/425
Chest protection conforms to the Level 1 requirements of EN 1621-3:2018
Back protection conforms to the Level 1 requirements of EN 1621-2:2014
Shoulder conforms to Type A Level 1 requirements of EN 1621-1:2012
Elbow Protection conforms to Type A Level 1 requirements of EN 1621-1:2012
Leatt ® protector back plates have been tested to EN1621-2:2014 and recorded a mean transmitted force of
below 18kN from a 50 Joule impact (Level 1).
Leatt ® protector chest plates have been tested to prEN1621-3:2015 and recorded a mean transmitted force
of below 18kN from a 50 Joule impact (Level 1).
Leatt ® protector Type A Shoulder protectors have been tested to EN1621-1:2012 and recorded a mean
transmitted force of below 35kN from a 50 Joule impact (Level 1).
Leatt
®
protector Type A Elbow protectors have been tested to EN1621-1:2012 and recorded a mean
transmitted force of below 35kN from a 50 Joule impact (Level 1).
Use
Products meeting the requirements of the technical specifications listed above are intended to reduce the
severity or incidence of soft tissue injuries such as bruising, contusions, cuts and abrasions during off-road
motorcycling and biking activities, such as Moto-X, Enduro, Downhill MTB, BMX and Adventure Sports.
- Products meeting the requirements of the technical specifications may reduce the severity and/or
incidence of some more serious injuries such as minor fractures.
- Products meeting the requirements of the technical specifications cannot significantly mitigate against
major injuries, such as serious fractures resulting from extreme impact forces or torsion/flexion/bending/
crushing injuries and neurological spinal injuries. Currently available materials and technology do not allow
this level of protection to be attained in products which would be acceptable to wear and which would
allow physical activities to be conducted and completed satisfactorily.
Protection dimension
The following illustrations demonstrate the dimensions of the zones of protection relative to the coverage
provided by the whole product.
4
WARNING
Copyright © 2023, Leatt ® Corporation
Publicité
