Publicité
OPERATING INSTRUCTIONS
REMOTE SCREEN INDICATORS
SLEEP
The sleep function can be used to conserve energy
during sleeping hours.
When selected, the set temperature will increase
by 1°C/2°F every half hour for one full hour. The
appliance will hold the new set temperature for
6 hours before automatically returning to normal
operation.
Note:
The Sleep function is not available in Fan or Dry
mode.
FOLLOW ME
There is a temperature sensor built into the remote
control that will monitor the room temperature. Keep
the remote control with you and the appliance will
automatically adjust the set temperature based on
the temperature where you are located.
The remote will display the temperature at its
location. The remote will send a signal to the air
conditioner every 3 minutes, so long as you remain
within range of the appliance.
The follow me light on the control panel will
illuminate for 5 seconds every 3 minutes to indicate
that it has received a signal from the remote. If the
appliance does not receive a signal from the remote
during any 7 minute interval it will beep to indicate
that the follow me mode has ended.
The maximum distance for the follow me feature is
8 meters (26 feet). This feature is available in cool
and auto modes.
Note:
The Follow Me function is available in Cool and
Auto mode.
LOCK
The Lock function will lock all of the buttons on the
remote to prevent accidental changes.
Press the LED and °C/°F buttons at the same time
and hold for a minimum of 5 seconds.
Note:
The Lock function can be cancelled by pressing
the LED and °C/°F buttons at the same time for 2
seconds.
SILENCE FEATURE
This feature can only be active by remote control.
Press and hold the fan button on the remote control
for 3 second to active silence feature.
16
Publicité
