ECOFOREST VAP 5-20 CW Manuel D'installation Et Maintenance page 60

6.14. Cleaning of the burn pot (VAP30). (Copper-based anti-seize paste for high temperatures). (3 lubrication
points).
After removing the hopper's front lining, take out the set made up of the burn pot with a cleaning system
and the combustion air intake pipe. Lubricate between the bushings and the shaft.
In addition, the compression spring must be replaced every 2 years (ECOFOREST Code 68731).

Bronze bushing.

Compression spring (replace every 2 years).
6.15. Cleaning of the burn pot VAP24 and VAP 5-20. (Lithium-based multipurpose grease, NLGI: 2).
Remove the rear protection, as shown in the figure, and, using a brush, apply grease to the cleaning system
rack. We recommend activating and de-activating the basket's opening system so that the grease permeates
the whole rack.

Screw.

Rear protection.

Rack.

Complete set.
6.16. Cleaning of the heat exchanger (the figure shows model VAP30, but the same applies to models VAP24 and
VAP 5-20 (Multipurpose lithium grease, NLGI: 2, 3 for forks). (8 lubrication points).
To access the lubrication points in the heat exchanger cleaning system, you must first remove the
exchanger's front and top rear lining. Lubricate between: the bushings and the shaft, the fork connection
shaft, the plain bearings and the shaft. In addition to the points shown in drawing 34, there are 2 more
bushings (located in the machine's front panel) that need lubrication.

Bronze bushing.

Fork.

Plain bearing.


59
Drawing 32


Drawing 33
Drawing 34