ECOFOREST VAP 5-20 CW Manuel D'installation Et Maintenance page 57


Cleaning hatches.
6.4.1. Cleaning grids (VAP24).
Once the boiler is unplugged, we shall unscrew the rear panel (see image) and the decanting plate to reach
the inside of the boiler.
After these parts have been removed, we shall vacuum the inside of the boiler and the decanting plate. Once
finished, we shall reassemble the plate.

Plates

Cleaning hatches.
6.4.2. Registering doors (VAP 5-20).
To access the registering doors, the right side plate and the rear grille should be removed.

Registering dooR.

Ceramic fiber joint (replace).
6.5. Cleaning of the gas outlet circuit. Always with the boiler disconnected. (Very important).
For an optimal cleaning of the extractor's collector, it is recommended to dismantle the extractor itself in
order to have full access to this zone for a better cleaning. Once the extractor is dismantled, clean it with a
dry brush and be careful with the turbine and structure.
When reassembling the exhaust it is COMPULSORY to replace the exhaust joint with a new one as you run
the risk of gas entering in our home.


56
Drawing 24


Drawing 25
 
Drawing 26