Publicité
1. Position the telescopic pole (1) in the bottom
slip-resistant cap (1a) and place the telescopic
pole upright (Fig. G).
Note: make sure that the holes of the bottom
slip-resistant cap and those of the telescopic pole
line up.
2. Fasten the telescopic pole (1) to the floor
with the long screws (5) and two washers (7)
(Fig. G).
3. Loosen the locking lever (1b) and pull out the
telescopic pole as far as needed (Fig. G).
Refasten the locking lever and tighten the
setscrews (1d) (Fig. H).
Note: if the locking levers are not sitting firmly
against the telescopic pole, tighten the knurled
screws when the locking lever is open. The
locking levers must be stiff when they are being
closed.
4. Extend the telescopic pole between the ceiling
and floor as much as possible. The spring must
be positioned precisely in the top slip-resistant
cap (Fig. H).
5. Turn the locking screw (1c) at the base of
the telescopic pole anti-clockwise until the
telescopic pole and the top slip-resistant cap
are sitting firmly against one another with no
space in between (Fig. H).
Attaching the crossbars
1. Remove the screws (1g) and the washers (1f)
from the telescopic pole.
2. Mount both crossbars (2) as shown in Figure I.
Aligning the crossbars
1. Loosen the screw (1g) and tilt the respective
crossbar into the desired position (Fig. K).
2. Tighten the screws once again to fasten the
crossbar.
3. Loosen the locking screw (1h) on the telesco-
pic pole and adjust the height of the respecti-
ve crossbar (Fig. L).
4. Fasten the respective crossbar with the locking
screw so that the crossbar cannot slide down
when weight is placed on it.
Attaching the hooks
1. Unscrew the locking screw (3a) from the
respective hook (3).
2. Mount the individual hooks as shown in
Figure J.
Changing the hook position
You can fasten the hooks either in the outer holes
or in the track of the crossbars (Fig. J).
1. Unscrew the locking screw (3a) from the
respective hook.
2. Slide the hook to the desired position (Fig. M).
3. Fasten the respective hook with the correspon-
ding locking screw.
Storage, cleaning
When not in use, always store the product clean
and dry at room temperature. Clean only with
water and wipe dry afterwards with a cloth.
IMPORTANT! Never clean the product with
harsh cleaning agents.
Disposal
Dispose of the article and the packaging materi-
als in accordance with current local regulations.
Packaging materials such as foil bags are not
suitable to be given to children. Keep the pack-
aging materials out of the reach of children.
Dispose of the products and the
packaging in an environmentally friendly
manner.
The recycling code is used to identify
various materials for recycling. The code
consists of the recycling symbol – which
is meant to reflect the recycling cycle – and a
number which identifies the material.
Notes on the guarantee and
service handling
The product was produced with great care and
under constant supervision. You receive a three-
year warranty for this product from the date of
purchase. Please retain your receipt.
The warranty applies only to material and
workmanship and does not apply to misuse or
improper handling. Your statutory rights, espe-
cially the warranty rights, are not affected by this
warranty.
GB/IE
13
Publicité
