Publicité
• The manufacturer accepts no liability for
accidents which occur as a result of ignoring
the safety information above or inappropriate
handling.
Preventing damage to the
product!
• In order to prevent damage to the bicycle, en-
sure that cables and wires do not get caught
on the product.
• Carbon frames are highly sensitive to pressu-
re! When mounting, handle your bicycle with
care to prevent damage to it.
Important pre-installation
information
WARNING! To ensure optimal stability of the
product, we recommend screwing the floor and
ceiling brackets in place.
If the product is not screwed to the floor and cei-
ling, the manufacturer is absolved of all liability.
WARNING! Before you begin installing the
product, measure the height between the floor
and the ceiling.
WARNING! Installing the product requires at
least two people due to its size.
Suitable installation site
For ceiling installation, a concrete ceiling or a
load-bearing wooden beam is suitable. For floor
installation, a concrete foundation or concrete
slabs of at least 50 x 50 x 5cm (L x W x H) are
suitable.
Note: if you attach the product to a wooden
beam, you must screw the product to it, as
wood warps depending on the temperature and
humidity. Enquire at a specialist retailer about
suitable installation materials.
Note: alternative installation conditions require
inspection of load-bearing capacity and durabili-
ty by a specialist company.
Suitable installation materials
Before installing the product, the installation
materials must be determined.
Enquire at a specialist retailer about suitable
installation materials for the floor and ceiling
brackets.
12
GB/IE
Installation
To install the product you will need the following
tools (not included in the package contents):
a suitable drill, measuring tape, and a Phillips
screwdriver.
Note: to ensure optimal stability of the product,
we recommend screwing the floor and ceiling
brackets in place.
Note: maintain sufficient distance from the wall
so that parts of the bicycle do not dirty the walls.
Installing the upper slip-resistant
cap
1. Position the slip-resistant cap (4) in the desired
position and mark a hole with a pencil
(Fig. B).
2. Using the appropriate tool, drill a hole in the
marked place. Insert a wall plug (9) into the
hole (Fig. C).
Note: use other wall plugs and screws if requi-
red for the installation surface.
3. Fasten the slip-resistant cap (4) to the ceiling
with the short screw (6) and a washer (7)
(Fig. D).
Installing the bottom slip-resistant
cap
1. Remove the slip-resistant cap (1a) from the
bottom end of the telescopic pole.
2. Plumb the exact position of the bottom slip-
resistant cap with a cord (not included in the
package contents). Mark the corresponding
spot and mark two opposing holes with a
pencil (Fig. E).
Note: the bottom slip-resistant cap (1a) must be
vertically below the top slip-resistant cap (4).
3. Using the appropriate tool, drill two holes in
the marked places. Insert a wall plug (8) into
each hole (Fig. F).
Note: use other wall plugs and screws if requi-
red for the installation surface.
Installing the telescopic pole
Important! Before installation, make sure that
the clamping sleeves with the locking levers are
sitting firmly on the thicker pipe of the telesco-
pic pole. Check the positioning of the cylinder
head screws (1e) and tighten them if necessary
(Fig. G).
Publicité
