Publicité
Read the following instructions carefully and be sure your barbecue is properly assembled, installed
and maintained. Failure to follow these instructions may result in serious bodily injury and/or property
damage. If you have any questions concerning assembly or operation, consult your dealer or LP
gas company.
•
DO NOT move the appliance during use.
•
DO NOT attempt to disconnect any gas fittings while the appliance is in use.
•
DO NOT use gas bottle if the bottle and/or valve are damaged, rusty, or dented as this may be
hazardous. Contact your supplier to have it checked.
•
This grill is designed to operate at an inlet pressure of: 11 inches water column.
•
DO NOT lean over an open grill and be mindful of hands/fingers near the edge of the cooking area.
•
Should a fire occur, turn off all gas burners, close the lid, and stand back from grill until fire is out.
•
Should flames go out while in operation, turn off all gas valves and leave lid open. Return to grill
after five minutes and try to relight the burners – following lighting instructions.
•
Keep children and pets away from grill when in use. Some parts of the grill will become very hot.
•
When cleaning the valves and burners, be careful not to stretch the valve orifices or burner ports.
•
Gas may still be present in a cylinder that appears to be empty. Adhere to proper transportation/
storage of the cylinder at all times.
•
If gas is leaking from cylinder, move away from cylinder immediately and call your gas supplier or
fire department. DO NOT try to address problem yourself.
•
DO NOT use a flame to check for gas leaks.
•
DO check for gas leaks and any obstructions to burners before use. This is especially important
after a period of storage or non-use.
•
Always connect or replace cylinder in a well-ventilated area, and never in the presence of a flame,
spark or heat source.
•
Grill must be kept away from flammable materials.
•
Do not alter this grill in any manner.
•
Do not touch metal parts of grill until it has completely cooled (about 45 minutes) to avoid burns,
unless you are wearing protective gear (BBQ mittens, pot holders, etc.).
•
Note that parts sealed by manufacturer or its agent must not be altered.
•
When assembling the grill, position the connection flexible tube so that it is protected
against twisting.
•
Stay away from any source of ignition when changing gas container.
•
When assembling the grill, do not obstruct ventilation openings of grill's container compartment. We
reserve the right to make minor technical adjustments to the device.
A-2
Publicité
